Cisco 6509 - Catalyst Chassis Switch Installation Manual page 89

Chapter 2 Preparing for Installation
Figure 2-1
ESD ground
strap
In addition, follow these guidelines when handling modules:
• Handle carriers by available handles or edges only; avoid touching the printed circuit boards or
connectors.
• Place a removed component board-side-up on an antistatic surface or in a static shielding container.
If you plan to return the component to the factory, immediately place it in a static shielding
container.
• Never attempt to remove the printed circuit board from the metal carrier.
For safety, periodically check the resistance value of the antistatic strap. The measurement should be
Caution
between 1 and 10 megohm (Mohm).
OL-5781-04
Attaching the ESD Wrist Strap Clip to the System Ground Lug Screw
Clip
Screw
Slide clip
behind screw
Clip installed
behind screw
WS-X6 K-SUP 2-2GE
CONSOL E
PORT
MODE
CONSOL E
SUPER VISOR 2
PCMCIA
OSM-4OC 12 POS-SI
4 PORT OC-12 POS
SM IR
OSM-4OC 12 POS-SI
4 PORT OC-12 POS
SM IR
Grounding lug
Side view of
grounding lug
System ground
connector
Switch Load
100%
PORT 1
PORT 2
EJECT
1%
Catalyst 6500 Series Switches Installation Guide
Site Requirements
2-9