Catalyst 6503 Switch - Cisco 6509 - Catalyst Chassis Switch Installation Manual

Catalyst 6503 Switch

Catalyst 6503 Switch
The Catalyst 6503 switch is a 3-slot horizontal chassis.
switch chassis.
the front view and
Table 1-1 Catalyst 6503 Switch Features
Feature
Chassis
Supervisor Engine
Modules
Backplane Bandwidth
Clock and VTT modules
Catalyst 6500 Series Switches Installation Guide
1-2
Table 1-2 lists the specifications of the Catalyst 6503 switch chassis.
Figure 1-2 shows the rear view of the Catalyst 6503 switch.
Description
Three horizontal slots. Slots are numbered from 1 (top) to 3 (bottom).
•
Supports Supervisor Engine 1, Supervisor Engine 2, Supervisor
•
Engine 32, and Supervisor Engine 720.
Supervisor engines are installed in slot 1 and slot 2.
–
Using a Supervisor Engine 32 or a Supervisor Engine 720 requires
–
that you install the optional high-speed fan tray.
The uplink ports are fully functional on the redundant supervisor engine
•
in standby mode.
Redundant supervisor engines must be configured identically.
Note
Supports up to two Catalyst 6500 series modules.
•
Does not support the WS-C6500-SFM and WS-X6500-SFM2 Switch
•
Fabric Modules.
• Does not support the WS-X67xx modules.
• Some Catalyst 6500 series modules may:
– Not be supported
Require that you install a Supervisor Engine 720
–
Have chassis slot restrictions
–
Require a specific software release level
–
Check your software release notes for specific information.
• 32 GBps shared bus.
• 720 GBps switch fabric.
One replaceable clock module (CLK-7600=) provides clocking signals
•
to the EOBC channel and the switching bus.
Non-replaceable voltage termination (VTT) module provides reference
•
voltage for bus signals.
Chapter 1
Table 1-1 lists the features of the Catalyst 6503
Product Overview
Figure 1-1 shows
OL-5781-04