Installing The Air Filter Assembly On A Catalyst 6509-Neb-A Switch (Optional) - Cisco 6509 - Catalyst Chassis Switch Installation Manual

Installing the Air Filter Assembly on a Catalyst 6509-NEB-A Switch (Optional)

Installing the Air Filter Assembly on a Catalyst 6509-NEB-A
Switch (Optional)
This section describes how to install the optional air filter assembly for the Catalyst 6509-NEB-A
switch. The filter assembly is not included with the chassis or bundle configurations. The necessary parts
can be ordered as listed in
installed on the chassis. This intake panel can be identified by the two filter assembly support loops
extending from the bottom front of the panel and the thumbscrews on the front left and right sides of the
panel. (See
Part Number
INTAKEPNL-09=
FLTRASSM-09=
FLTRINSERTS-09=
Perform these steps to install the new filter assembly. If INTAKEPNL-09= is already installed, skip to
Step
Remove the intake panel by unscrewing four thumbscrews. (See
Step 1
Figure 4-57 Removing the Intake Panel
Install the new intake panel by tightening four thumbscrews. (See
Step 2
Catalyst 6500 Series Switches Installation Guide
4-66
Table
Figure 4-58.)
Table 4-3
3.
o
4-3. The filter assembly installation requires that INTAKEPNL-09= be
Air Filter Part Numbers
Description
Replacement Intake Panel
Filter Cage Assembly, no filter inserts included
Set of five replacement air filter inserts for
FLTRASSM-09=
o
INPUT
FAN OUTPU T
OK OK
FAIL
INPUT FAN
OK
OK
Chapter 4 Removal and Replacement Procedures
Figure 4-57.)
OUTPU T
FAIL
Figure 4-58.)
OL-5781-04