Catalyst 6513 Switch - Cisco 6509 - Catalyst Chassis Switch Installation Manual

Catalyst 6513 Switch

Catalyst 6513 Switch
Table 1-19
Catalyst 6513 switch chassis.
Table 1-19 Catalyst 6513 Switch Features
Feature
Chassis
Supervisor Engines
Modules
Catalyst 6500 Series Switches Installation Guide
1-50
lists the features of the Catalyst 6513 switch chassis.
Figure 1-13
Description
Thirteen horizontal slots. Slots are numbered from (1) top to (13)
•
bottom.
Supports Supervisor Engine 2, Supervisor Engine 32, and Supervisor
•
Engine 720.
Supervisor Engine 2 is installed in slot 1 and slot 2.
–
Supervisor Engine 1A is not supported.
–
Supervisor Engine 32 and Supervisor Engine 720 are installed in
–
slot 7 and slot 8.
Supervisor Engine 32 and Supervisor Engine 720 require that you
–
install the high-speed fan tray. You must also install a 2500 W or
higher capacity power supply in the chassis to power the high-speed
fan tray.
Supervisor Engine 720 has built-in switching fabric. Switch Fabric
–
Modules are not supported by Supervisor Engine 720 and cannot be
installed in the same chassis.
The uplink ports are fully functional on all redundant supervisor engine
•
models when they are in standby mode.
Redundant supervisor engines must be configured identically.
Note
Supports up to 12 Catalyst 6500 series modules.
•
WS-C6500-SFM and WS-X6500-SFM2 Switch Fabric Modules must be
•
installed in slot 7 or slot 8.
WS-X6748-SFP, WS-X6748-GE-TX, and WS-X6704-10GE modules
•
are not supported in slots 2–8; they are supported in slots 9–13.
Slots 1–8 support a single fabric channel; slots 9–13 support dual
–
fabric channels.
Some Catalyst 6500 series modules may:
•
Not be supported
–
Require that you install a Supervisor Engine 720
–
Have chassis slot restrictions
–
– Require a specific software release level
Check your software release notes for specific information.
Table 1-20
shows a view of the Catalyst 6513 switch chassis.
Chapter 1 Product Overview
lists the specifications of the
OL-5781-04