Installing The Ac-Input Pem - Cisco 6509 - Catalyst Chassis Switch Installation Manual

Chapter 4 Removal and Replacement Procedures
Figure 4-42 AC-Input PEM (PEM-20A-AC+ Shown)
AC power
Captive installation screws
Figure 4-43 Handling a PEM

Installing the AC-Input PEM

Follow these steps to install an AC-input PEM:
Ensure that the system (earth) ground connection has been made. For ground connection instructions,
Step 1
see the
If necessary, remove the blank PEM filler plate (Cisco part number 800-16719-01) from the chassis PEM
Step 2
bay opening by loosening the captive installation screws. Retain the blank PEM filler plate for future use.
Grasp the PEM with one hand. Place your other hand underneath the PEM, as shown in
Step 3
Slide the PEM into the PEM bay. Make sure that the PEM is fully seated in the bay.
Tighten the PEM captive installation screws. (See
Step 4
OL-5781-04
IEC 60320 C19 connector
switch
WS-X6K -SUP2-2 GE
CONSOLE
SUPERV ISOR2
OSM-4OC1 2 POS-SI
4 PORT OC-12 POS SM
IR
OSM-4OC1 2 POS-SI
4 PORT OC-12 POS SM
IR
"Establishing the System Ground" section on page
Removing and Installing the Power Entry Modules (PEMs)
Switch Load
CONSOLE 100%
PORT
MODE PORT 1
PCMCIA
EJECT
1%
Figure 4-42.)
Catalyst 6500 Series Switches Installation Guide
PORT 2
3-22.
Figure 4-43.
4-53