Removing And Installing The Fan Assembly; Required Tools; Removing The Fan Assembly - Cisco 6509 - Catalyst Chassis Switch Installation Manual

Chapter 4 Removal and Replacement Procedures
Figure 4-47 DC-Input PEM Terminal Block Screws
DC PEM 1
terminal block
Figure 4-48 DC-Input PEM
Captive installation screws

Removing and Installing the Fan Assembly

This section describes how to remove and install fan assemblies for the Catalyst 6500 series switches.

Required Tools

You might need a flat-blade or number 2 Phillips-head screwdriver to loosen or tighten the captive
installation screws on the power supply.

Removing the Fan Assembly

The fan assembly is designed to be removed and replaced while the system is operating without
presenting an electrical hazard or damage to the system.
OL-5781-04
DC PEM 1 DC PEM 2
screws
WS-X6 K-SUP 2-2GE
CONSOL E
PORT
MODE
CONSOL E
SUPER VISOR 2
OSM-4OC 12 POS-SI
4 PORT OC-12 POS
SM IR
OSM-4OC 12 POS-SI
4 PORT OC-12 POS
SM IR
Catalyst 6503 DC PEM
Cable clips
Switch
Load
100%
PORT 1
PCMCIA
EJECT
1%
Catalyst 6500 Series Switches Installation Guide
Removing and Installing the Fan Assembly
PORT 2
4-57