Configuring Snmp Reload-Enable - Cisco 11503 - CSS Content Services Switch Administration Manual

Chapter 5 Configuring Simple Network Management Protocol (SNMP)

Configuring SNMP Reload-Enable

OL-5647-02
reporter-transition - Generates SNMP enterprise traps when the CSS
•
reporter transitions state. A trap is generated when the reporter is activated or
suspended, or the VRID peering virtual routers or critical phy interfaces
change state.
service-transition - Generates SNMP enterprise traps when a CSS service
•
transitions state. A trap is generated when a service fails and when a failed
service resumes proper operation.
For example, to enable an SNMP enterprise trap when a CSS login failure occurs,
enter:
(config)# snmp trap-type enterprise
(config)# snmp trap-type enterprise login-failure
To disable all enterprise traps, enter:
(config)# no snmp trap-type enterprise
To disable a specific enabled enterprise trap, use the no form of the snmp
trap-type enterprise command. For example, to prevent the CSS from generating
traps when a power supply fails, enter:
(config)# no snmp trap-type enterprise chmgr-ps-transition
To reboot the CSS using SNMP, use the snmp reload-enable command. The
syntax and options for this global configuration mode command are:
• snmp reload-enable - Allows any SNMP write to the apSnmpExtReloadSet
object to force a CSS reboot. The reload object, apSnmpExtReloadSet, is
located at 1.3.6.1.4.1.9.9.368.1.22.7. You can find this object in the CSS
Enterprise MIB, snmpext.mib.
snmp reload-enable reload_value - Allows an SNMP write equal to the
•
reload_value to force a CSS reboot.
This command requires that you enable enterprise traps first using the
Note
snmp trap-type enterprise command. See the
Enterprise Traps" section.
Cisco Content Services Switch Administration Guide
Defining the CSS as an SNMP Agent
"Configuring SNMP
5-21