Configuring Disks In A Two-Disk Css - Cisco 11503 - CSS Content Services Switch Administration Manual

Configuring Disks in a Two-Disk CSS

Cisco Content Services Switch Administration Guide
B-26
Select option 2 to display the boot configuration.
4.
When check disk is enabled, no state information appears in the
Miscellaneous field of the boot configuration:
***************** IP/MAC Information ***************
IP Address:
Subnet Mask:
MAC Address:
***************** PRIMARY **************************
Boot Type:
Boot File:
***************** SECONDARY ************************
Boot Type:
Boot File:
Press <Enter> to continue...
The CSS 11501 and the SCM in the CSS 11503 and CSS 11506 contain two
PCMCIA slots for a hard disk or Flash disk. These disks contain the CSS system
software and are also used for logging and storing offline system files. The two
disks are identified by the PCMCIA slots (slot 0 and slot 1) in which they are
installed. Disk 0 is the default storage location for the primary and secondary boot
records in the CSS. The default storage location for log files and core dumps in
the CSS is the specified disk from which the CSS boots (disk 0 or disk 1).
To specify the CSS disk that is to be the storage location for booting (primary and
secondary boot disk), for logging output, and for core dumps:
Select option 4 from the Advanced Options menu to configure the disks in the
1.
active SCM.
The CSS prompts you to specify the disk for the primary boot record.
Set Primary-Boot to which PCMCIA slot? (0,1):
Enter either 0 for the disk in slot 0 (the default setting) or 1 for the disk in
2.
slot 1.
The CSS prompts you to specify the disk for the secondary boot record.
Set Secondary-Boot to which PCMCIA slot? (0,1):
Appendix B Using the Offline Diagnostic Monitor Menu
10.3.6.58
255.0.0.0
00-10-58-00-12-ca
DISK
sg0730002
DISK
sg0720104
OL-5647-02