Logging Acl Activity - Cisco 11503 - CSS Content Services Switch Administration Manual
Content services switch
Hide thumbs
Also See for 11503 - CSS Content Services Switch:
- Configuration manual (250 pages) ,
- Hardware installation manual (184 pages) ,
- Getting started manual (142 pages)
Table of Contents
Advertisement
Chapter 4
Using the CSS Logging Features
Logging ACL Activity
OL-5647-02
level level - The log level for the message. Enter one of the levels, from 0 to
•
7, as shown in
Table
cliLogMessage subsystem name "message" level ?
When you configure the CSS to log ACL activity, the CSS logs the event of the
packet matching the clause and ACL. The CSS sends log information to the
location you specified in the logging command.
Before you configure logging for a specific ACL clause, ensure global ACL
logging is enabled. To globally enable ACL logging, use the logging subsystem
acl level debug-7 command in configuration mode.
To configure logging for an ACL clause:
Enter the ACL mode for which you want to enable logging.
1.
(config)# acl 7
(config-acl[7])#
2.
Enable logging for:
A new clause, by entering the log option at the end of the clause. For
•
example:
(config-acl[7])# clause 1 deny udp any eq 3 destination any eq
3 log
An existing clause, by using the clause log enable command:
•
(config-acl[7])# clause 1 log enable
To disable ACL logging for a specific clause, enter:
(config-acl[7])#) clause 1 log disable
To globally disable logging for all ACL clauses, enter:
(config)# no logging subsystem acl
4-4. To see a list of levels, enter:
Cisco Content Services Switch Administration Guide
Configuring Logging for a Subsystem
4-11
Advertisement
Table of Contents
