Configuring A Scheduled Software Image Reload - Cisco Catalyst 9200 Configuration Manual

Configuring a Scheduled Software Image Reload

SUMMARY STEPS
1. switch:BOOT=<source path of .bin file>
2. boot
3. show version
DETAILED STEPS
Command or Action
Step 1 switch:BOOT=<source path of .bin file>
Example:
Step 2
boot
Example:
switch: boot
Step 3 show version
Configuring a Scheduled Software Image Reload
This task describes how to configure your device to reload the software image at a later time.
SUMMARY STEPS
1. configure terminal
2. copy running-config startup-config
3. reload in [hh:]mm [text]
4. reload at hh: mm [month day | day month] [text]
5. reload cancel
6. show reload
DETAILED STEPS
Command or Action
Step 1
configure terminal
Example:
Device# configure terminal
Step 2 copy running-config startup-config
Example:
Device# copy running-config startup-config
Step 3 reload in [hh:]mm [text]
Example:
Device# reload in 12
System Management Configuration Guide, Cisco IOS XE Gibraltar 16.10.x (Catalyst 9200 Switches)
74
Performing Device Setup Configuration
Purpose
Sets the boot parameters.
Boots the device.
Verifies that the device is in the BUNDLE mode.
Purpose
Enters global configuration mode.
Saves your device configuration information to the startup
configuration before you use the reload command.
Schedules a reload of the software to take affect in the
specified minutes or hours and minutes. The reload must
take place within approximately 24 days. You can specify