Table 6-1 Rmon Event Configuration Quick Start - Cisco 11503 - CSS Content Services Switch Administration Manual

Chapter 6 Configuring Remote Monitoring (RMON)
Table 6-1
Steps and Possible Settings
1.
2.
3.
4.
5.
6.
The following running-configuration example shows the results of entering the
commands in
!************************* RMON EVENT *************************
rmon-event 1
OL-5647-02
RMON Event Configuration Quick Start
Create an RMON event index from global configuration mode. Enter an
integer from 1 to 65534.
(config)# rmon-event 1
Create Event <1>, [y/n]:y
Assign an existing SNMP community for this event. The specified
community_name is the name of an SNMP community configured using the
snmp trap-host command. This step is required only if the traps are sent to
an SNMP network management station.
(config-rmonevent[1])# community moonbase_alpha
Provide a description for the event. Enter a quoted text string with a maximum
of 127 characters including spaces.
(config-rmonevent[1])# description "This event occurs when service
connections exceed 100"
Assign the owner who defined and is using the resources of the event. Enter a
quoted string with a maximum of 127 characters including spaces. You must
define the owner before you can activate the event.
(config-rmonevent[1])# owner "Boston Tech Lab"
Specify the type of event notification. The type determines where the
notification is sent.
(config-rmonevent[1])# type log-and-trap
Activate the event.
(config-rmonevent[1])# active
Table 6-1.
community moonbase_alpha
description "This event occurs when service connections exceed 100"
owner "Boston Tech Lab"
type log-and-trap
active
Cisco Content Services Switch Administration Guide
Configuring an RMON Event
6-5