Configuring Snmp Trap Source - Cisco 11503 - CSS Content Services Switch Administration Manual
Content services switch
Hide thumbs
Also See for 11503 - CSS Content Services Switch:
- Configuration manual (250 pages) ,
- Hardware installation manual (184 pages) ,
- Getting started manual (142 pages)
Table of Contents
Advertisement
Chapter 5
Configuring Simple Network Management Protocol (SNMP)
Configuring SNMP Trap Source
OL-5647-02
For example:
(config)# snmp trap-host 172.16.3.6 sqalab1 snmpv2
To remove a specified trap host, enter:
(config)# no snmp trap-host 172.16.3.6
To set the Agent-Address field in the traps generated by the CSS, use the snmp
trap-source command. This command applies only to SNMPv1 and does not
apply to SNMPv2C. The syntax of this global configuration mode command is:
snmp trap-source [egress-port|management |specified source_ip_address]
The options and variable for this command are:
egress-port - Uses the VLAN circuit IP address configured on the egress port
•
to set the Agent-Address field of the trap. You do not need to enter an IP
address because the address is determined dynamically by the CSS.
management - Uses the Ethernet management port IP address to set the
•
Agent-Address field of the trap. This option is available only on a Cisco
11500 series CSS.
specified source_ip_address - Allows you to enter the IP address to be used
•
in the Agent-Address field of the traps. Enter the IP address in dotted-decimal
notation (for example, 192.168.11.1)
For example:
(config)# snmp trap-source egress-port
To return SNMP source traps to the default of the management port IP address,
enter:
(config)# no snmp trap-source
Cisco Content Services Switch Administration Guide
Defining the CSS as an SNMP Agent
5-17
Advertisement
Table of Contents
