Using Cli Commands To Enable The Wds Server - Cisco C3201FESMIC-TP= - 3201 Fast EN Switch Mobile Interface Card Expansion Module Software Configuration Manual

WDS, Fast Secure Roaming, and Radio Management
Step 13 Select CiscoSecure Database from the Password Authentication drop-down menu.
Step 14 In the Password and Confirm Password fields, enter exactly the same password that you entered on the
access point on the Wireless Services AP page.
Click Submit.
Step 15
Step 16 Repeat
Step 17 Browse to the System Configuration page, click Service Control, and restart ACS to apply your entries.
Figure 7
Figure 7

Using CLI Commands to Enable the WDS Server

The following command-line interface (CLI) commands are required to enable the WDS server. The no
form of the commands disables the WDS server. The same configuration applies for Central WDS server
and per subnet WDS server. The same configuration applies to WMIC.
[no] wlccp wds priority <1-255> interface BVI1
[no] wlccp authentication-server infrastructure <method_infra>
where <method_infra> is <authentication server list name>
[no] wlccp authentication-server client [any | eap | leap | mac] <method_client>
where <method_ client > is <authentication server list name>
[no] aaa group server radius infra
[no] aaa group server radius client
[no] aaa authentication login <method_infra> group infra
where <method_infra> is <named authentication list>
Step 10 through Step 15
shows the System Configuration page.
ACS System Configuration Page
[no] server <IP address of RADIUS server> auth-port <Port number> acct-port <Port
number>
[no] server <IP address of RADIUS server> auth-port <Port number> acct-port <Port
number>
for each access point that uses the WDS access point.
Cisco 3200 Series Wireless MIC Software Configuration Guide
Configuring WDS and Fast Secure Roaming
9