Cisco C3201FESMIC-TP= - 3201 Fast EN Switch Mobile Interface Card Expansion Module Software Configuration Manual page 181

Cisco Discovery Protocol
Command
Step 1
configure terminal
Step 2 no cdp run
Step 3 end
To enable CDP, follow these steps, beginning in privileged EXEC mode:
Command
Step 1 configure terminal
Step 2 cdp run
Step 3 end
This example shows how to enable CDP.
bridge# configure terminal
bridge(config)# cdp run
bridge(config)# end
Disabling and Enabling CDP on an Interface
CDP is enabled by default on all supported interfaces to send and receive CDP information.
To disable CDP on an interface, follow these steps, beginning in privileged EXEC mode:
Command
Step 1 configure terminal
Step 2 interface interface-id
Step 3
no cdp enable
Step 4
end
Step 5 copy running-config startup-config
To enable CDP on an interface, follow these steps, beginning in privileged EXEC mode:
Command
Step 1 configure terminal
Step 2 interface interface-id
Step 3
cdp enable
Step 4
end
Step 5
copy running-config startup-config
Purpose
Enters global configuration mode.
Disables CDP.
Returns to Privileged Exec mode.
Purpose
Enters global configuration mode.
Enables CDP after disabling it.
Returns to privileged EXEC mode.
Purpose
Enters global configuration mode.
Enters interface configuration mode, and enter the
interface on which you are disabling CDP.
Disables CDP on an interface.
Returns to privileged EXEC mode.
(Optional) Saves your entries in the configuration file.
Purpose
Enters global configuration mode.
Enters interface configuration mode, and enter the
interface on which you are enabling CDP.
Enables CDP on an interface after disabling it.
Returns to privileged EXEC mode.
(Optional) Saves your entries in the configuration file.
Cisco 3200 Series Wireless MIC Software Configuration Guide
Configuring CDP
3