Cisco C3201FESMIC-TP= - 3201 Fast EN Switch Mobile Interface Card Expansion Module Software Configuration Manual page 252

Error and Event Messages
Table 2 Error and Event Messages (continued)
Message
SOAP-4-UNZIP_OVERFLOW: Failed
to unzip
flash:/c1200-k9w7-mx.122-3.6.JA1/ht
ml/level15/ap_xxx.htm.gz, exceeds
maximum uncompressed html size
802.11 Subsystem Messages
DOT11-6-FREQ_INUSE: Radio
frequency [int] is in use
DOT11-6-FREQ_USED: Radio
frequency [int] selected
DOT11-4-VERSION_MISMATCH:
Require radio version [hex].[int], found
version [hex].[int]
DOT11-2-VERSION_INVALID:
Unable to find required radio version
[hex].[int]
DOT11-4-NO_SSID: No SSIDs
configured, radio not started
DOT11-4-FLASHING_RADIO:
Flashing the radio firmware ([chars])
DOT11-2-NO_FIRMWARE: No radio
firmware file ([chars]) was found
DOT11-2-BAD_FIRMWARE: Radio
firmware file ([chars]) is invalid
DOT11-4-FLASH_RADIO_DONE:
Flashing the radio firmware completed
DOT11-4-LINK_DOWN: Radio parent
lost: [chars]
DOT11-4-CANT_ASSOC: Cannot
associate: [chars]
Inter-Bridge Protocol Messages
DOT11-6-ROAMED: Station
[mac-address] Roamed to [mac-address]
DOT11-6-STANDBY_ACTIVE:
Standby to Active, Reason = [chars]
([int])
Cisco 3200 Series Wireless MIC Software Configuration Guide
10
Explanation
The HTTP server cannot retrieve a
compressed file in response to an HTTP
GET request because the size of the file is
too large for the buffers used in the
uncompression process.
When scanning for an unused frequency,
the unit recognized another radio using
the displayed frequency.
After scanning for an unused frequency,
the unit selected the displayed frequency.
When starting the radio, the wrong
firmware version was found. The radio
will be loaded with the required version.
When trying to re-flash the radio
firmware, the device recognized that the
radio firmware packaged with the IOS
firmware had the incorrect version.
All SSIDs were deleted from the
configuration. At least one must be
configured for the radio to run.
The radio has been stopped to load new
firmware.
When trying to flash new firmware into
the radio, the file for the radio was not
found in the flash file system.
When trying to flash new firmware into
the radio, the file was found to be invalid.
The radio firmware flash is complete, and
the radio will be restarted with the new
firmware.
The connection to the parent bridge was
lost for the displayed reason. The unit
will try to find a new parent bridge.
The unit could not establish a connection
to a parent bridge for the displayed
reason.
A station has roamed to a new bridge.
The device is transitioning from standby
mode to active mode.
WIMIC Troubleshooting
Recommended Action
Make sure file is a valid HTML page. If
so, you'll have to copy an
uncompressed version of the file into
flash to retrieve it through HTTP.
None.
None.
None.
None.
Configure at least one SSID on the
device.
None.
The wrong image has been loaded into
the unit. Locate the correct image based
on the type of radio used.
Put the correct firmware image file in
the place where the unit is looking.
None.
None.
Check the configuration of both the
parent bridge and this unit to make sure
the basic settings (SSID, WEP, and
others) match.
None.
None.