Error And Event Messages - Cisco C3201FESMIC-TP= - 3201 Fast EN Switch Mobile Interface Card Expansion Module Software Configuration Manual

Error and Event Messages

Step 6 When the boot loader upgrade is complete, enter the boot command at the console prompt to reboot the
device.
Enter the version command to verify that it boots using the upgraded boot loader.
Step 7
Example Command Output
bridge: copy tftp://223.255.254.253/tftpboot/jrehage/loader_c3202_bs.img bs:
................................................................
File "tftp://223.255.254.253/tftpboot/jrehage/loader_c3202_bs.img" successfully copied to
"bs:"
bridge:reset
Are you sure you want to reset the system (y/n)?y
System resetting...
flashfs[0]:136 files, 6 directories
flashfs[0]:0 orphaned files, 0 orphaned directories
flashfs[0]:Total bytes:15998976
flashfs[0]:Bytes used:7458304
flashfs[0]:Bytes available:8540672
flashfs[0]:flashfs fsck took 30 seconds.
Base ethernet MAC Address:00:ff:ff:f0:01:4f
Initializing ethernet port 0...
Reset ethernet port 0...
Reset done!
ethernet link up, 100 mbps, full-duplex
Ethernet port 0 initialized:link is up
Error and Event Messages
This section lists the CLI error and event messages.
explanation and recommended action for each message.
Table 2 Error and Event Messages
Message
Software Auto Upgrade Messages
SW_AUTO_UPGRADE-FATAL:
Attempt to upgrade software failed,
software on flash may be deleted. Please
copy software into flash.
SW_AUTO_UPGRADE-7-FAILURE:
dhcp_client_start_stop failed
SW_AUTO_UPGRADE-7-FAILURE:
Failed to obtain ip addr from dhcp server
SW_AUTO_UPGRADE-7-FAILURE:
boot_file_pathent creation failed
Association Management Messages
Cisco 3200 Series Wireless MIC Software Configuration Guide
8
Xmodem file system is available.
Explanation
Auto upgrade of the software failed. The
software on the flash memory might have
been deleted. Copy software into the flash
memory.
Auto upgrade of the software failed due
to error in starting/stopping DHCP client
process.
Auto upgrade of the software failed.
Auto upgrade of the software failed due
to error in creation of pathent (internal
data structure).
Table 2 lists the errors and events and provides an
Recommended Action
Copy software before rebooting the
unit.
Copy the error message exactly as it
appears and report it to your technical
support representative.
Copy the error message exactly as it
appears and report it to your technical
support representative.
Copy the error message exactly as it
appears and report it to your technical
support representative.
WIMIC Troubleshooting