Configuring Authentication Types; Default Authentication Settings - Cisco C3201FESMIC-TP= - 3201 Fast EN Switch Mobile Interface Card Expansion Module Software Configuration Manual

Authentication Types
Command
Step 1
configure terminal
Step 2 dot1x credentials name
Step 3 username name
Step 4 password password
Step 5 pki-trustpoint name
Step 6 end
The following example shows how to specify a trustpoint:
keeling-ap#conf t
Enter configuration commands, one per line.
keeling-ap(config)#dot1x credentials test
keeling-ap(config-dot1x-creden)#username myname
keeling-ap(config-dot1x-creden)#password mypass
keeling-ap(config-dot1x-creden)#pki-trustpoint TP_001
keeling-ap(config-dot1x-creden)#end
keeling-ap#sh run | beg test
dot1x credentials test
username myname
password 7 060B16314D5D1A
pki-trustpoint TP_001

Configuring Authentication Types

This section describes how to configure authentication types. You attach authentication types to the
WMIC's SSID. See
contains these topics:
•
•
•

Default Authentication Settings

The default SSID on the WMIC is autoinstall.
default SSID:
Table 1
Feature
SSID
"Service Set Identifiers"
Default Authentication Settings, page 15
Assigning Authentication Types to an SSID, page 16
Configuring Authentication Holdoffs, Timeouts, and Intervals, page 24
Default Authentication Configuration
Purpose
Enters global configuration mode.
Specifies the name of the trustpoint.
Specifies the user name for setting up the trustpoint.
Specifies the user password for setting up the trustpoint.
Specifies the pki-trustpoint name.
Returns to privileged EXEC mode.
End with CNTL/Z.
for details on setting up the WMIC SSID. This section
Table 1 shows the default authentication settings for the
Default Setting
autoinstall
Cisco 3200 Series Wireless MIC Software Configuration Guide
Configuring Authentication Types
15