Safety With Electricity - Cisco Catalyst 8300 Series Hardware Installation Manual

Safety with Electricity

• Wear an ESD-preventive wrist strap, ensuring that it makes good skin contact. Connect the clip to an
• If no wrist strap is available, ground yourself by touching a metal part of the chassis.
Note
Safety with Electricity
Follow these general guidelines when working on equipment that is powered by electricity:
• Locate the emergency power-off switch in the room in which you are working. If an electrical accident
• Disconnect all power before doing the following:
• Look carefully for possible hazards in your work area, such as moist floors, ungrounded power extension
• Do not work alone if hazardous conditions exist.
• Never assume that power is disconnected from a circuit. Always check.
• Never open the enclosure of the internal power supply.
• If an electrical accident occurs, proceed as follows:
Follow these guidelines when working with any equipment that is disconnected from a power source but is
still connected to ethernet wiring or other network cabling:
• Never install ethernet wiring during a lightning storm.
• Never install ethernet jacks in wet locations unless the jack is specifically designed for it.
• Never touch uninsulated ethernet wires or terminals unless the ethernet line is disconnected atthe network
• Use caution when installing or modifying ethernet lines.
• Remove power cables from all installed power supplies before opening the chassis.
Cisco Catalyst 8300 Series Edge uCPE Hardware Installation Guide
10
unpainted surface of the chassis frame to channel unwanted ESD voltages safely to ground. To guard
against ESD damage and shocks, the wrist strap and cord must operate effectively.
For the safety of your equipment, periodically check the resistance value of the anti-static strap. It should be
between 1 and 10 megaohms (Mohm).
occurs, you can quickly turn off the power.
• Installing or removing a chassis.
• Working near power supplies.
cables, frayed power cords, and missing safety grounds.
• Turn off power to the device.
• Call for help.
• Determine if the person needs rescue breathing or external cardiac compressions; then take appropriate
action.
interface.
Prepare for Installation