Chapter 2
Installing the Cisco ME 1200 NID
The rubber feet are included in the accessory kit. Attach the four adhesive rubber feet to the bottom of the
Step 1
switch
Figure 2-5
Figure 2-6
1
Set the device on a flat surface near a power source, making sure there are at least two inches of space on all
Step 2
sides for proper air flow.
Installing and Removing SFP Modules
Installing SFP Modules
Figure 2-7 shows a SFP module that has a bale-clasp latch.
OL-31962-04
Attaching the adhesive rubber feet
On Table Reference
Rubber feet
Cisco ME 1200 Series Carrier Ethernet Access Devices Hardware Installation Guide
Installing and Removing SFP Modules
2-9