Remove Small Form Pluggable Modules - Cisco Catalyst 8300 Series Hardware Installation Manual

Remove Small Form Pluggable Modules

3. Disconnect fan cables from the motherboard.
4. Remove the fan tray by lifting up out of the chassis.
5. To install, perform these operations in reverse.
Figure 1: Removing/Installing the fan
tray
1
2
Remove Small Form Pluggable Modules
Follow these steps to remove a Small Form Pluggable (SFP) from the device:
Step 1
Read the Safety Warnings section and disconnect the power supply before you perform any module replacement.
Step 2 Disconnect all cables from the SFP.
Invisible laser radiation may be emitted from disconnected fibers or connectors. Do not stare into beams or
Warning
view directly with optical instruments. Statement 1051
Caution The latching mechanism used on many SFPs locks the SFP into place when cables are connected. Do not
pull on the cabling in an attempt to remove the SFP.
Cisco Catalyst 8300 Series Edge uCPE Hardware Installation Guide
38
Install and Upgrade Field Replaceable Units
Screws
Fan tray