Installing Drive Bays - Cisco Catalyst 8300 Series Hardware Installation Manual

Install and Upgrade Field Replaceable Units
2. Tighten the screw.
Figure 1. PIM slot

Installing Drive Bays

If you have not ordered drives, the drive bay slot is closed with a blank cover.
These are the steps to install a drive in a drive bay:
E1.S Modules
Note
1. Remove the filler in the E1.S slot
2. Press the latch-release button on the E1.S module so that the latch springs to the open position.
3. Slide the E1.S module in the slot and push forward until the module seats in the connector.
4. To secure the module in the chassis, close the latch until it catches the latch-release button.
Figure 1: Inserting the E1.S module in the slot
1 Securing screw
The drive bay is in the front panel of the device. The bay is closed with a cover if there are no drives in the
slots.
2
Cisco Catalyst 8300 Series Edge uCPE Hardware Installation Guide
Installing Drive Bays
PIM Module
35