Facp Configuration; Input Zones - Honeywell fire-lite alarms MRP-2002E Manual

Read Status
The following screens will be displayed:
READ STATUS
1=FACP CONFIG

2=INPUT ZONES

3=OUTPUT CIRCUITS
Read Status Screen #1
READ STATUS
1=CROSS INPUT ZONES
2=ON-BOARD RELAYS
3=SYSTEM SETTINGS
Read Status Screen #2

4.15.1 FACP Configuration

Pressing 1 while viewing Read Status Screen #1 will display the type of configuration programmed
into the FACP (refer to "FACP CONFIG (Application Templates)" on page 50). As an example, if
Template 1 was programmed as the FACP configuration, the following screen will be displayed:
4.15.2 Input Zones
Pressing 2 while viewing Read Status Screen #1 will cause the following screens to be displayed:
Pressing the down arrow key will allow the selection of Zones 4-6.
MRP-2002 & MRP-2002E PN 53049:A1 5/01/2008
1=TIMERS
2=DAYLIGHT SAVINGS
3=HISTORY
1=PRINT
2=ANN-BUS
READ FACP CONFIG
TEMPLATE 1
CROSS-ZONE SYSTEM
WITH HORN
READ INPUT ZONES
1=ZONE 1
2=ZONE 2
3=ZONE 3
Operating Instructions
READ STATUS
Read Status Screen #3
READ STATUS
Read Status Screen #4
93