Table of Contents
Advertisement
Programming
SYSTEM SETUP
1=TIME-DATE
2=TROUBLE REMIND
3=CHARGR DISABLE
System Setup Screen #2
70
3.5.6.4 Time-Date
The control panel time and date can be changed by pressing 1 while viewing the System Setup
Screen #2. The following screen will be displayed:
1=TIME
2=DATE
3=CLOCK FORMAT
1=DAYLIGHT SAVINGS
3.5.6.4.1 Time
To change the time, press 1 while viewing the Time-Date Screen. The following screen will be
displayed:
ENTER TIME AS 12HRS
1=AM
A flashing cursor is located toward the top left of the display. Below the cursor is the current
time. To change the time, enter the two-digit hours followed by the two-digit minutes. The
cursor will move one position to the right each time a digit is entered. After the last minutes
digit is entered, the cursor will again move one position to the right. At this point enter 1 for
AM or 2 for PM. The display will then return to the Time-Date Screen which will show the
new time entry. If an error is made while entering a digit, press the CLR key to delete the entire
entry and beginning again.
3.5.6.4.2 Date
To change the date, press 2 while viewing the Time-Date Screen. The following screen will be
displayed:
A flashing cursor is located toward the top left of the display. Below the cursor is the current
date. To change the date, enter the two-digit month followed by the two-digit day and then the
two-digit year (01 for 2001, 02 for 2002, etc.). The cursor will move one position to the right
each time a digit is entered. After the last year digit is entered, the display will return to the
Time-Date Screen which will show the new date entry. If an error is made while entering a
digit, press the CLR key to delete the entire entry and beginning again.
TIME AND DATE
04072006
Time-Date Screen #1
TIME AND DATE
Time-Date Screen #2
:
10:00
Time Screen
ENTER DATE
**-**-****
MONTH DAY YEAR
04-07-2006
Date Screen
MRP-2002 & MRP-2002E PN 53049:A1 5/01/2008
Master Programming Level
10:00A
12HR
2=PM
Advertisement
Table of Contents
