Procedure To Install Flange Adapters; Wiring The St 700 Standard Transmitter; Figure 13 - St 700 Standard Transmitter - Flange Adapter Removal And Replacement - Honeywell SmartLine ST 700 User Manual

4.5.4 Procedure to Install Flange Adapters

The following procedure provides the steps for removing and replacing an optional flange adapter on
the process head. Refer to
This procedure does not require that the meter body be removed from the electronics
housing. If flange adapters are being replaced with parts from other kits (for example,
process heads), follow the procedures for the kits and incorporate the following procedure.
The threaded hole in each flange adapter is offset from center. To ensure proper orientation
for re-assembly, note the orientation of the offset relative to each process head before
removing the adapter.
Figure 13 – ST 700 Standard Transmitter - Flange Adapter Removal
Refer to the instructions included with the kit for removal and replacement procedures.
4.6

Wiring the ST 700 Standard Transmitter

Page 26
Figure 13.
and Replacement
ST 700 SmartLine Pressure Transmitters User's Manual
Revision 13