Honeywell SmartLine ST 700 User Manual page 196

6ШклЦАП
[6SPANTR]
DAC Span Trim
Note: Loop must be
removed from
Automatic Control
7ТокТст
[7 LPTEST]
Loop Test
Note: Loop must be 12.000
removed from
Automatic Control
8УстLRV
Set LRV
[ 8SETLRV]
9УстURV
Set URV
[ 9SETURV]
10Кнтрст
Contrast level
[ 10CNTRST]
11КорLRV
Calibration Methods
[11LRVCOR]
12КорURV
Calibration Methods
[12URVCOR]
Page 180
ST 700 SmartLine Pressure Transmitters User's Manual
This selection allows the
loop span output 20mA
value to be trimmed.
Note: You must connect a
current meter to the
transmitter to monitor the
loop output.
This selection allows the
user to force the DAC output
to any value between 3.8
and 20.8 mA.
Note: This selection will put
the DAC into Fixed Output
Mode, as indicated by the
flashing output value.
Navigation away from this
menu item will return the
loop to Normal (Automatic)
Mode.
Executing this selection
performing for Zero
operation.
Note: The PV value shown
in bottom line will be
available in Pressure Units
(Simple Display pressure
unit)
Executing this selection for
Span operation
Note: The PV value shown
in bottom line will be
available in Pressure Units
(Simple Display pressure
unit)
Adjust the LCD contrast
level.
Range from » (1) to
»»»»»»»»» (7)
Default: »»»»»»» (7)
perform an input calibration
correction by applying
process input at the
configured LRV level.
perform an input calibration
correction by applying
process input at the
configured URV level.
the next digit
to the right
Press  to
enter menu
selection
 to select
number.
 to enter
and shift to
the next digit
to the right
Press  to
enter menu
selection
Press  to
initiate action
Press  to
enter Menu
selection
Menu to
select level.
 to Enter
Press  to
enter menu
selection
Press  to
initiate action
Press  to
enter menu
selection
Press  to
initiate action
Revision 13