Model Name
Terminals
Digital Video Input
(HDMI terminal)
Audio Signal Support
Maximum Display
Resolution
Audio Output
USB Host
USB Device
Speaker
Scanning
Horizontal
Frequencies
Vertical
5
Wireless Support*
Operating Temperature
Operating Humidity
Operating Altitude
Light Source Life
Remote Controller Range*
*1 When the Bright Mode setting is "On". ISO 21118:2012 standard.
*2 When the Light Control setting is 5. ISO 21118:2012 standard.
*3 Shows overall average value when the projector is shipped from the factory. This type of entry is
governed by ISO 21118:2012 data projector specifications. Measurement methods and conditions
are based on Appendix B.
*4 Dedicated port for YW-41 wireless adapter.
*5 When YW-41 Wireless Adapter is connected.
*6 The supported distance between the remote controller and projector is less when there is a large
angle between the remote controller and the projector's remote controller receiver. The supported
distance is shorter when the remote controller batteries are low.
*7 When using a new battery under normal temperature.
*8 When using a new battery under normal temperature, no wireless communication, no output from
speaker.
Specifications are subject to change without notice.
■ AC adapter (AD-1979PL)
INPUT : AC 100 to 240V, 50/60Hz, 2.25A
OUTPUT : DC 19.0V, 7.9A, 150.1W
Average active efficiency : 89.0 (%)
Efficiency at low load (10%) : 79.0 (%)
No-load power consumption : 0.15 (W)
B
Micro-USB type B × 1: For firmware update and logo data registration
6
CX-E1
HDMI type A × 1, HDCP support
No
1920 × 1200 resizing
–
–
–
28.1 to 74.0kHz
50 to 60Hz
–
5 to 35°C (41 to 95°F)
20 to 80% (non-condensation)
0 to 3,000 meters (0 to 10,000 feet) above sea level
Approximately 20,000 hours (6,000 hours guaranteed)
5 meters (16.4 feet) maximum
Within 30° up, down, left, right of center of
remote control signal receiver.
80
CX-F1
Yes
3.5 mm stereo mini jack × 1
USB type A × 1*
4
1W × 1, Monaural
IEEE 802.11b/g/n compatible