Casio CX-E1 User Manual page 57

Use this menu item:
Screen Settings 3
Horizontal Keystone
Correction
Screen Settings 3
Correction Priority
Screen Settings 3
Aspect Ratio
Screen Settings 3
Projection Mode
Screen Settings 3
Ceiling Mount
Screen Settings 3
No Signal Screen
Screen Settings 3
Blank Screen
Screen Settings 3
Auto Projection Off
Screen Settings 3
Mirror
Screen Settings 3
Restore Menu Defaults
C
To do this:
Correct horizontal keystoning of the projected image.
Enable or disable keystone corrected projection image distortion reduction.
Shape*: Reduces projected image distortion when keystone correction is performed.
The resulting projection area will be slightly smaller than normal.
Size: With this setting, the normal projection area size is maintained for a keystone
corrected image, but there may be some projected image distortion.
Select an aspect ratio setting for the projected image.
See "Changing the Aspect Ratio of the Projected Image" (page 51) for more
information.
Specify whether projection will be from the front of the screen or the back of the
screen.
Front*: Select this option to project from the front of the screen.
Rear: Select this option to project from the back of the screen. This setting flips the
front projected image horizontally.
Set up the projector to be positioned upside down for mounting on a wall.
On: Select when the projector is positioned upside down for mounting on a wall.
Since the bottom of the projector is upwards, the projected image is flipped
both horizontally and vertically.
Off*: Select when the projector is used on a desktop. This projects the image
assuming that the top of the projector is upwards.
Select one of the following as the projection image whenever there is no input signal
being input to the projector: "Blue"* (blue screen), "Black" (black screen), "Logo"
(projector built-in logo, or user logo, page 41), "Test Pattern". Also note that
selecting "Test Pattern" for this item will cause Auto Power Off (page 35) and Auto
Projection Off (page 62) to be disabled while a test pattern is being projected when
there is no signal.
Note
 The "No Signal Screen" setting will not be shown on the Setup Menu while
a battery is connected to the projector. In this case, the setting is fixed as
"Blue".
Select one of the following as the projection image whenever the remote controller
[BLANK] key (page 61) is pressed: "Blue" (blue screen), "Projection Off"* (light off),
"Logo" (projector built-in logo, or user logo, page 41), "Test Pattern".
Note
 The "Blank Screen" setting will not be shown on the Setup Menu while a
battery is connected to the projector. In this case, the setting is fixed as
"Projection Off".
Specify whether or not to turn off the projection light automatically when the input
signal from the input source device is lost during projection.
Enable: Auto Projection Off enabled.
Disable*: Auto Projection Off disabled.
For details about the Auto Projection Off operation, see "Using Auto Projection Off"
(page 62).
See "Flipping the Projected Image Horizontally (Mirror Mode)" (page 53).
Return all of the items in the "Screen Settings" menu to their initial defaults for the
currently projecting image source.
57