Casio CX-E1 User Manual page 73

Problem
Turning on projector power
causes the following
message to appear
"Please input the
password." and the
projector stands by for
password input.
The remote controller does
not work.
The STATUS indicator is
flashing or lit.
The light source unit does
not light.
Power suddenly turns off
and the projector restarts.
Important!
 Try performing the following steps, which may or may not return the projector to normal
operation.
1. Disconnect the AC adapter (or battery) and wait for at least 10 minutes.
2. Reconnect the AC adapter (or battery) and turn the projector back on again.
 If normal operation does not resume after you perform the above steps, take the
projector to your retailer or authorized CASIO service center.
The "Option Settings 1 3 Password 3 Power On Password" setting on the setup
menu is turned on, so the projector is password protected. Input the correct
password, and then press the [ENTER] key. See page 66.
 The remote controller batteries may be dead. Replace the batteries.
 The remote controller may be too far from the projector. Make sure the remote
controller is within about five meters from the projector when performing
operations.
Some error may have occurred. See "Indicator Status When an Error Occurs" (page
71).
The light source unit has reached the end of its service life or it is malfunctioning.
Contact your original dealer or authorized CASIO service center for replacement.
The projector periodically performs a self-check operation. In rare cases, the result of
a self-check may cause the projector to restart automatically. This normally does not
indicate malfunction, so you can continue using the projector. However, malfunction
may be indicated if successive restarts keep occurring. If this happens contact your
original dealer or authorized CASIO service center.
Cause and Recommended Action
73