Enabling And Disabling Auto Projection Off; Auto Projection Off Projection Light Control - Casio CX-E1 User Manual

Enabling and Disabling Auto Projection Off

Auto Projection Off is disabled under initial projector default settings. To enable Auto Projection Off,
change "Screen Settings 3 Auto Projection Off" (page 57) on the Setup Menu to "Enable".

Auto Projection Off Projection Light Control

Projection Light Off Conditions
If the image input signal from the input source device to the projector is lost for some reason while
projection is being performed, the no signal screen (page 57) or the network standby screen*
(Network Model Only) appears first. If no operation is performed for about 10 seconds, the projection
light turns off.* 2
The following message will be displayed for about five seconds before the light turns off: "Auto
Projection Off is enabled. The projector will stop projecting."
Auto Projection Off operation is not affected by whether audio is being input.
*1 For details about the network standby screen, refer to the separate "Network Function Guide".
*2 With the network model, the audio is also muted.
Regardless of the current Auto Projection Off setting, Auto Projection Off is not triggered while any
one of the following conditions exists.
 If there has been no projection from any input source since the projector was turned on.
 While a test pattern (page 54) is being projected.
Projection Light Restoration Conditions
The projection light relights when the projector detects input of an image signal or when a key
operation is performed on the projector or the optional remote controller.
Projector Operation While the Projection Light is Off
 The POWER/STANDBY indicator (green) flashes slowly while the projection light is turned off by the
Auto Projection Off function.
 Regardless of the Auto Power Off setting (page 35), the projector will turn off automatically if no key
operation is performed and there is no input signal to the projector for a preset amount of time (see
below) after the projection light turns off.
– AC adapter power: Approximately 20 minutes
– Battery power: Approximately 5 minutes
63
1