Install The Poe Converter Power Supply - Cisco Catalyst 8300 Series Hardware Installation Manual

Install Internal Components and Field Replaceable Units

Install the PoE Converter Power Supply

To install the PoE converter power supply, perform these steps:
Step 1
Push the POE power supply into the slot, continue until the supply is fully seated. The power supply latch should rotate
until it touches the faceplate of the supply.
Step 2
Tighten the screw to secure the filler panel in the chassis.
Step 3 Tighten the two screws securing the POE supply in the device.
Step 4
Install the fan tray from the device.
Step 5 Tighten the screws securing the fan tray in the chassis.
Figure 64: Install the PoE Converter Power Supply
1 Latch to secure module (shown open).
3 PoE converter module installed in PoE slot 0
5 Latch to secure PoE converter module (shown closed).
The following messages are expected behavior when you try to reload or insert a PoE supply in a device with Ethernet
Switch Network Module:
Example:
*Jul 21 22:35:23.868: %IOSXE_PEM-6-INSPEM_FM: PEM/FM slot POE0 inserted
Upon PoE converter power supply insertion, inline power supply restores automatically in the router.
2 PoE converter module being installed in PoE slot
1
4 Screws to secure PoE module to the chassis.
Hardware Installation Guide for Cisco Catalyst 8300 Series Edge Platforms
Install the PoE Converter Power Supply
85