Replace The Cover - Cisco Catalyst 8300 Series Hardware Installation Manual

Install Internal Components and Field Replaceable Units
Step 3
Place the chassis on a flat surface.
Step 4 For C8300-1N1S-4T2X|6T, remove the 11 cover screws. For C8300-2N2S-4T2X|6T, remove the 6 cover screws.
Step 5
Lift the cover straight up.

Replace the Cover

To replace the cover, perform the following steps.
Step 1
Place the chassis on a flat surface.
Step 2 Drop the cover straight down and ensure that the side flanges insert into the chassis. Care should be taken to not damage
the EMC Gaskets.
Step 3 For C8300-1N1S-4T2X|6T install the 11 cover screws. For C8300-2N2S-4T2X|6T install the 6 cover screws.
Figure 34: Install the Cover on the C8300-1N1S-4T2X|6T
1 Chassis
cover
2 Screws
3 Chassis
Hardware Installation Guide for Cisco Catalyst 8300 Series Edge Platforms
Replace the Cover
59