Install Network Interface Modules In The Nim Adapter - Cisco Catalyst 8300 Series Hardware Installation Manual

Install Network Interface Modules in the NIM Adapter

Figure 75: Cisco Catalyst SM-NIM Adapter in C8300-2N2S-4T2X|6T
2. Align the Catalyst NIM adapter with the guides in the chassis walls or slot divider and slide it gently into
a service module (SM) slot on the router.
3. Push the Catalyst NIM adapter into place until you feel the edge connector seat securely into the connector
on the router backplane. The faceplate should contact the chassis rear panel.
4. Using a number 1 Phillips screwdriver, tighten the captive screws on the network interface module.
5. Check the LED on the Catalyst NIM adapter and confirm proper operation.
Note
6. (Optional) Install either one or two network interface modules into the Catalyst NIM adapter after it has
been installed in the chassis. Follow the instructions for installing the NIM.
Install Network Interface Modules in the NIM Adapter
The Cisco Catalyst NIM adapter provides two network interface module (NIM) slots. To install a NIM into
the adapter, follow the instructions for the NIM.
Note
Hardware Installation Guide for Cisco Catalyst 8300 Series Edge Platforms
102
Description
1 Chassis
2 Cisco C-SM-NIM adapter
A solid green LED indicates that the Catalyst NIM adapter is correctly inserted. It may take several
seconds for the adapter to start before the LED is solid green.
• Install the Cisco Catalyst NIM adapter into the router chassis before installing any NIMs into the
adapter.
• Before removing the Cisco Catalyst NIM adapter from the chassis, first remove any NIMs that
have been installed into the adapter.
Install Cisco Catalyst Network Interface Module