Remove A Module; Insert A Module - Cisco Catalyst 8300 Series Hardware Installation Manual

Remove a Module

Remove a Module
From a console terminal run the hw-module subslot subslot stop command. The service module adapter
LED blinks, turns off, and the console displays a prompt signaling the module can be removed. See the
following output:
Device# hw-module subslot 2/0 stop
Proceed with stop of module? [confirm]
damo-O2#
*Mar 22 20:43:31.088: %SPA_OIR-6-OFFLINECARD: SPA (SM-X-1T3/E3) offline in subslot 2/0
*Mar 22 20:43:31.088: %IOSXE_OIR-6-SOFT_STOPSPA: SPA(SM-X-1T3/E3) stopped in subslot 2/0,
interfaces disabled
Device# show hw-module subslot 2/0 oir
Module Model Operational Status
------------- -------------------- ------------------------
subslot 2/0 SM-X-1T3/E3 stopped

Insert a Module

You require to run this step only if you run the oir-stop command when the module is not physically removed
from the slot. If the module is physically removed, you do not require to run this command.
From a console terminal issue the hw-module sm {slot} oir-start command. The console displays output that
shows the module change states:
Device# hw-module sm 2 oir-start
Device#
*Nov 11 21:06:17.546: %ATMOC3POM-6-SFP_IN: Interface ATM2/0 OC3 MM SFP has been inserted.
Router#
*Nov 11 21:06:19.442: %LINK-3-UPDOWN: Interface ATM2/0, changed state to up
*Nov 11 21:06:20.442: %LINEPROTO-5-UPDOWN: Line protocol on Interface ATM2/0, changed state
to up
Hardware Installation Guide for Cisco Catalyst 8300 Series Edge Platforms
118
Online Insertion and Removal and Hot-Swapping