Remove The Poe Converter Power Supply - Cisco Catalyst 8300 Series Hardware Installation Manual

Remove the PoE Converter Power Supply

Step 4
Tighten the screws securing the fan tray in the chassis.
Remove the PoE Converter Power Supply
To remove the PoE converter power supply, follow these steps:
Step 1
Remove the fan tray from the device.
Step 2 Loosen the screws securing the fan tray in the chassis.
Step 3
Remove the fantray from the device.
Step 4 Loosen the two screws securing the POE supply in the device.
Step 5
Rotate the PoE latch and pull the supply out of the slot.
Figure 63: Remove the PoE Converter Power Supply
1 Latch to secure module (shown open).
3 PoE converter module installed in PoE slot 0
5 Latch to secure PoE converter module (shown closed).
Hardware Installation Guide for Cisco Catalyst 8300 Series Edge Platforms
84
Install Internal Components and Field Replaceable Units
2 PoE converter module being installed in PoE slot
1
4 Screws to secure PoE module to the chassis.