Day/Night Settings; Figure 4-2 Video Orientation - Honeywell 60 Series Configuration Manual

Honeywell 60 Series IP Camera Software Configuration Guide
•
Select both Flip and Mirror if the camera is installed upside-down (e.g., on the ceiling) to
correct the image orientation.
•
Rotate: Rotate the video by 90 degrees or 270 degrees. The rotation here indicates
clockwise rotation. Rotation can be applied with flip, mirror, and physical lens rotation
settings to adapt to different mounting locations, such as a corridor.

Figure 4-2 Video Orientation

Original Flip
The flip/mirror/rotate operation will clear the video settings,
Note privacy mask settings, exposure window, motion detection
settings, preset position and focus window.

Day/Night Settings

Switch to B/W in night mode: Check to enable the camera to automatically switch to
Black/White during night mode.
Mode:
•
Auto mode (The Day/Night Exposure Profile will not be available if Auto mode is selected)
The camera automatically removes the filter by judging the level of ambient light.
Note Select auto mode will disable profile of exposure settings.
•
Day mode
In day mode, the camera switches on the IR cut filter at all times to block infrared light
from reaching the sensor so that the colors will not be distorted.
•
Night mode
In night mode, the camera switches off the IR cut filter at all times for the sensor to accept
infrared light, thus helping to improve low light sensitivity.
•
Schedule mode
The camera switches between day mode and night mode based on a specified schedule.
Enter the start and end time for day mode. The time format is [hh:mm] and is expressed in
24-hour clock time. By default, the start and end time of day mode are set to 07:00 and
18:00.
20
Original Mirror
Rotate 90
degrees
Original
clockwise
( )