Configuring User Accounts Settings - Honeywell 60 Series Configuration Manual

Honeywell 60 Series IP Camera Software Configuration Guide
7. Click OK, and then click OK to close the Certificate window. And now your browser will not
display a warning that the connection is not private/secure.
Please ensure to install the certificate to ensure a secure
Note
communication with the camera and to avoid delays in the web
page navigation.
Export configuration file
Enter a password for exporting the configuration file and then click EXPORT to export all
parameters for the camera and user-defined scripts.
Update daylight saving time rules
Follow the steps below to update daylight saving time rules:
1. Click CHOOSE FILE under Update daylight saving time rules.
2. Select the XML file to update.
3. Click UPLOAD.
Upload configuration file
Follow the steps below to upload a configuration file:
1. Enter the password for uploading the configuration file. The password must be the same
with the password of the configuration file you set for exporting, or the uploading will be
failed. For example, if you set the password A for the configuration file A and you set the
password B for the configuration file B. When you want to upload the configuration file B,
you must use the password B.
2. Click CHOOSE FILE to locate the configuration file and then click UPLOAD to upload the
configuration file.
The model and firmware version of the device should be the same as the configuration file. If
you have set up a fixed IP or other special settings for your device, it is not suggested to
update a configuration file.
If the power is disconnected during firmware upgrade or if there is unknown reason causing
abnormal LED status, and a Restore cannot recover normal working condition, you can
perform the following steps to activate the camera with its backup firmware:
a. Press and hold down the reset button for at least one minute.
b. Power on the camera until the Red LED blinks rapidly.
c. After boot up, the firmware should return to the previous version before the camera
hanged. (The procedure should take 5 to 10 minutes, longer than the normal boot-up
process). When this process is completed, the LED status should return to normal.

Configuring User Accounts Settings

Go to Setup System Setup User Accounts.
82