Configuring User Accounts Settings - Honeywell 30 Series Manual

Update Daylight Saving Time Rules
Follow the steps below to update daylight saving time rules:
1. Click CHOOSE FILE under "Update daylight saving time rules".
2. Select the XML file to update.
3. Click UPLOAD.
Update Custom Language File
1. Click CHOOSE FILE under "Update custom language file".
2. Select your custom language file to update.
3. Click UPLOAD.
4. Go to the main page (see
Language menu to apply the custom language.
Upload Configuration File
Follow the steps below to upload a configuration file:
1. Enter a password for uploading the configuration file.
The password must be the same as the password of the configuration file you set for
exporting, or the uploading will be failed. For example, if you set a password A for a
configuration file A and you set a password B for a configuration file B. When you want
to upload the configuration file B, you must use the password B.
2. Click CHOOSE FILE to locate the configuration file and then click UPLOAD to upload
the configuration file.
The model and firmware version of the device should be the same as the
Note: configuration file. If you have set up a fixed IP or other special settings for your
device, it is not suggested to update a configuration file.

Configuring User Accounts Settings

Go to Setup  System Setup  User Accounts.
This section describes how to create multiple accounts and grant privileges to these
accounts.
82
Figure 17), and select your own custom language from the
Honeywell 30 Series IP Cameras User Guide