Configuring Network Event Settings; Figure 7-13 Network Event; Table 7-8 Network Configuration - Honeywell Performance Series User Manual

Performance Series IP Camera Software Configuration Guide
interacts with the linked alarm devices.
Alarm The Alarm linkage keeps running for the configured time after alarm is
Delay
ended.
Send
When enabled, the system sends an email alert when the event occurs.
Email
Capacity Enter a value between 0-99. If the capacity of SD card exceeds the set value,
Limit it will send a warning.
Emails cannot be sent if the network is offline or if there is an IP
Note
conflict.

Configuring Network Event Settings

Go to Setup  Video Analytics 

Figure 7-13 Network Event

Table 7-8 Network Configuration

Parameter Function
Event
Select a network event type in the dropdown list.
Type
Enable Check to enable the selected network event type.
Record If Record is enabled, the selected event type can activate recording.
Record The system will wait for the specified time before it begins recording. Select
Delay from 10s to 300s.
Select the Relay-out check box, and when alarm is triggered, the system
Relay-out
interacts with the linked alarm devices.
Alarm The Alarm linkage keeps running for the configured time after alarm is
Delay ended.
64
Abnormality
Network.