Table 6-1 Tcp/Ip Configurations - Honeywell Performance Series User Manual

Performance Series IP Camera Software Configuration Guide

Table 6-1 TCP/IP Configurations

Parameter
Hostname
Ethernet Card
Mode
MAC Address
IP Version
IP Address
Preferred DNS
Server
Alternate DNS
Server
Enable ARP/Ping to
set IP address
service
36
Function
Configure to set the current host camera's name.
Maximum 32 characters.
Select an Ethernet port. The default is Wire (Default).
Note If you modify these settings, you should reboot your
camera to activate the new setup.
Select Static or DHCP mode.
The IP Address, Subnet mask, and Default Gateway fields are
unavailable when you select DHCP mode to automatically
search for the IP address.
If Static mode is selected, you must manually assign the IP
Address, Subnet mask, and Default Gateway.
If DHCP mode is selected, the IP Address, Subnet mask, and
Default Gateway are assigned automatically.
Note IP Address, Subnet mask, Default Gateway, and DHCP
are read-only when PPPoE is enabled.
Displays the MAC address.
Select the IP version you are using: IPv4 or IPv6.
If Static mode is selected, type values for the IP Address, Subnet
mask, and Default Gateway.
Enter the preferred DNS server IP address.
Enter an alternate DNS server IP address.
If you know the camera's MAC address, then use the ARP/Ping
command to modify or set the camera's IP address.
Before operating the camera, please ensure that the network
camera and the PC are in the same LAN.
Perform the following steps to set the IP address:
1. Get an IP address. Set up the network camera and the PC in
the same LAN.
2. Get the physical address from the label on the network
camera.
3. Open the Run interface (Start menu > Run), and then type the
following commands:
arp -s <IP Address> <MAC> ping -l
480 -t <IP Address>
For example:
arp -s 192.168.0.125 11-40-8c-18-10-11 ping -l
480 -t 192.168.0.125
4. Reboot the camera. If the setup was successful, output
information such as Reply from 192.168.0.125... will appear
in the command output lines.