Configuring Firewall Settings; Figure 6-12 Firewall - Honeywell Performance Series User Manual

Configuring Firewall Settings

Configure Network Access, PING prohibited and Prevent Semijoin to enhance network and
data security. This section takes Network Access as an example.
Network Access: Set trusted list and restricted list to limit access.
•
• Allowlist: Only when the IP/MAC of your PC in the allowlist, can you access the camera.
Ports are the same.
Blocklist: When the IP/MAC of your PC is in the blocklist, you cannot access the camera.
•
Ports are the same.
PING prohibited: Enable PING prohibited function, and the camera will not respond to the
•
ping request.
• Prevent Semijoin: Enable Prevent Semijoin function, and the camera can provide service
normally under Semijoin attack.
You cannot set allowlist or blocklist for camera IP or MAC addresses.
You cannot set allowlist or blocklist for port MAC addresses.
When the IP addresses of the camera and your PC are in the same LAN, MAC
Note
verification takes effect.
When you access the camera through internet, the camera verifies the MAC
address according to the router MAC.
1. Go to Setup  Network Setup Firewall Firewall.

Figure 6-12 Firewall

2. Select Network Access from Rule Type list, and then select the Enable check box.
3. Check Mode by Allowlist and Blocklist.
4. Click Add IP/MAC.
Configuring Network Settings
45