Configuring System Events; Configuring Sd Card Event Settings; Configuring Network Event Settings - Honeywell Performance Series User Manual

Configuring System Events

You can configure system event settings (for SD card and network errors and illegal login
attempts) on the Setup > Event > Abnormality page.

Configuring SD Card Event Settings

There are three types of SD card events:
You can configure settings for each type of event.
To enable SD card event detection:
1.
2.
3.
4.

Configuring Network Event Settings

There are two types of network events:
You can configure settings for each type of event.
• No SD Card: There is no microSD card installed in the camera.
• SD Card Error: The installed microSD card is not working.
• Capacity Warning: The installed microSD card is full.
On the SD Card tab, select the event type that you want to configure from the Event
Type list (No SD Card, SD Card Error, or Capacity Warning).
Select the Enable check box.
To send an email notification when the event is detected, select the Send Email check
box. Email settings must be configured in Setup > Network > SMTP (Email). See
Configuring Email Settings
Click Save to apply the settings.
• Disconnection: The camera is offline.
• IP Conflict: The camera has the same IP address as another device on the network.
Configuring Events and Alarms | 67
on page 49.
800-23288 - A - 07/2017