Configuring Audio Detection Settings; Table 7-3 Scene Change Configurations - Honeywell Performance Series User Manual

Performance Series IP Camera Software Configuration Guide

Table 7-3 Scene Change Configurations

Parameter
Enable
Period
Record
Record Delay
Relay-out
Alarm Delay
Send Email
Snapshot

Configuring Audio Detection Settings

This function is supported by
H4W2PER2V/HBW2PER2V/HEW2PER3V/H4W4PER3V/H4W4PER2V/HEW4PE
Note
R2V/HEW4PER3V/HBW4PER2V/H4W8PER1V/H4W8PER2V/HEW8PER2V/HB
W8PER2V/HBW8PER1V.
1. Go to Setup  Video Analytics  Audio Detection.
2. Configure the parameters.
56
Function
Check to enable scene change.
The camera scene change function is activated during the specified
period.
See Configuring the Alarm Period
You can configure up to six periods per day. Select a date. If you do
not select a date, the current setup will be applied to today only.
You can select All to apply the alarm period to the whole week.
Click Save to exit.
If Record is enabled, a scene change event can activate recording.
The system will wait for the specified time before it begins recording.
Select from 10s to 300s.
Select the Relay-out check box, and when alarm is triggered, the
system interacts with the linked alarm devices.
The Alarm linkage keeps running for the configured time after alarm is
ended.
When enabled, the system sends an email alert when an alarm occurs.
When enabled, the system attaches a snapshot to an email alert when
an alarm occurs.
on page 51.