Configuring Smart Plan; Configuring Ivs; Figure 7-7 Smart Plan - Honeywell Performance Series User Manual

Performance Series IP Camera Software Configuration Guide
Anti-Dither
Record
Record Delay
Send Email
Snapshot

Configuring Smart Plan

Smart plan is a master switch for the intelligent analytics such as Face Detection and People
Counting. The device intelligent functions can be valid after smart plan is enabled.
Go to Setup  Video Analytics  Smart Plan. Select the plan by clicking its icon and click
Save.

Figure 7-7 Smart Plan

Configuring IVS

Set rules for IVS as Tripwire or Intrusion which is applicable for scenes with sparse targets
and no occlusion among targets, such as the perimeter protection of unattended area.
1. Go to Setup  Video Analytics  IVS  Rule Config.
2. Click to add rules for IVS.
name.
58
Click OK to save the changes. The system goes back to the scene
change interface. Click Save to exit.
Enter the anti-dither time in seconds. Enter a value between 0 and 100
seconds. The system will only allow one motion detection event within
this period.
If Record is enabled, an audio detection event can activate recording.
The system will wait for the specified time before it begins recording.
Select from 10s to 300s.
When enabled, the system sends an email alert when an alarm occurs.
When enabled, the system attaches a snapshot to an email alert when
an alarm occurs.
Double-click the name to modify the rule