Configuring Network Settings; Tcp/Ip - Honeywell Performance HDZP252DI User Manual

52 | Performance Series IR 1080p IP PTZ Camera User Guide

Configuring Network Settings

TCP/IP

www.honeywell.com/security
Figure 5-15 TCP/IP Interface
Table 5-13 TCI/IP Configuration
Parameter Function
Configure to set the current host camera's name. Maximum 32
Host Name
characters.
Select an Ethernet port. The default is Wire.
Ethernet Card
Note
Select Static or DHCP mode.
If Static mode is selected, you must manually assign the IP
Address, Subnet mask, and Default Gateway values.
If DHCP mode is selected, the IP Address, Subnet mask, and
Mode
Default Gateway are assigned automatically and the fields are
grayed out.
Note
MAC Address Displays the MAC address.
IP Version Select the IP version you are using: IPv4 or IPv6.
If you modify these settings, you will have to reboot your
camera to activate the new setup.
IP Address, Subnet mask, Default Gateway, and DHCP
are read-only when PPPoE is enabled.