Cisco Firepower 4110 Hardware Installation Manual page 81

Installation, Maintenance, and Upgrade
Figure 56: Attach the Cable Management Bracket to the Slide Rail Locking Bracket
1 Cable management bracket
3 8-32 x 0.375 inch Phillips screws (two per side)
Step 5 Connect the cables to the ports. Install the cables according to your default software configuration as described in the
Cisco Firepower 4100 Getting Started
cable mounting brackets (as shown in Step 6 below).
If you are installing the FIPS opacity shield after the initial product installation, the cables are connected. If
Note
the attached cables do not have enough slack to route them through the cable mounting brackets (as shown
below), you will have to turn the power off on the appliance, remove the cables, route the cables through the
cable mounting brackets, reattach the cables, and continue with Step 7 below.
Step 6 Route the cables through the openings in the cable management brackets.
2 Slide rail locking bracket
Guide. Make sure that the cables have enough slack to route them through the
Cisco Firepower 4110, 4120, 4140, and 4150 Hardware Installation Guide
Install the FIPS Opacity Shield
77