1-Gb Sx/10-Gb Sr/10-Gb Lr Network Module With Hardware Bypass - Cisco Firepower 4110 Hardware Installation Manual

1-Gb SX/10-Gb SR/10-Gb LR Network Module with Hardware Bypass

Table 2: 40-Gb BASE-SR Cable Specifications
Interface
Ethernet 40-G BASE-SR4
850 nm wavelength
MPO-12 port adapter
Note See the
We recommend the following Cisco OM3 MTP/MPO cables.
Table 3: Cisco Cables
Cisco Part Number
CAB-ETH-40G-5M
CAB-ETH-40G-10M
CAB-ETH-40G-20M
1-Gb SX/10-Gb SR/10-Gb LR Network Module with Hardware Bypass
The following figure shows the front panel of the 1-Gb SX, 10-Gb SR and 10-Gb LR hardware bypass network
modules (FPR4K-NM-6X1SX-F, FPR4K-NM-6X10SR-F, FPR4K-NM-6X10LR-F). This is a single-wide
module that does not support hot swapping. The six ports are numbered from top to bottom, left to right. Pair
ports 1 and 2, 3 and 4, and 5 and 6 to form hardware bypass paired sets.
Note Make sure you have the correct firmware package and software version installed to support this network
module. For instructions on how to verify your firmware package version and to upgrade the firmware if
necessary, see the
FXOS Compatibility
Cisco Firepower 4110, 4120, 4140, and 4150 Hardware Installation Guide
18
Cisco 40GBASE QSFP Modules Data Sheet
Cisco Firepower 4100/9300 FXOS Firmware Upgrade
for the software compatibility matrix.
Supported Cable
50 microns core diameter
2000/4700 (OM3/4) modal bandwidth (MHz*km)
50 m cable distance
for specifications of the QSFP for the 40-Gb BASE-SR-4.
Cable Length
5 m
10 m
20 m
Guide. See
Overview
Cisco Firepower 4100/9300