Network Equipment-Building System (Nebs) Statements - Cisco Firepower 4110 Hardware Installation Manual

Network Equipment-Building System (NEBS) Statements

Warning
Statement 1040 Product Disposal
Ultimate disposal of this product should be handled according to all national laws and regulations.
Warning
Statement 1045 Short-Circuit Protection
This product requires short-circuit (overcurrent) protection to be provided as part of the building installation.
Install only in accordance with national and local wiring regulations.
Warning Statement 1074 Comply with Local and National Electrical Codes
To reduce risk of electric shock or fire, installation of the equipment must comply with local and national
electrical codes.

Network Equipment-Building System (NEBS) Statements

NEBS describes the environment of a typical United States Regional Bell Operating Company (RBOC) central
office. NEBS is the most common set of safety, spatial, and environmental design standards applied to
telecommunications equipment in the United States. It is not a legal or regulatory requirement, but rather an
industry requirement.
The following NEBS statements apply to the Firepower 4120:
Warning Statement 7003 Telcordia GR-1089 NEBS Standard for Electromagnetic Compatibility and Safety
The intrabuilding port(s) of the equipment or subassembly must use shielded intrabuilding cabling/wiring that
is grounded at both ends.
Warning Statement 7005 Intrabuilding Lightning Surge and AC Power Fault
The intrabuilding port(s) of the equipment or subassembly must not be metallically connected to interfaces
that connect to the outside plant (OSP) or its wiring. These interfaces are designed for use as intrabuilding
interfaces only (Type 2 or Type 4 ports as described in GR-1089-CORE) and require isolation from the exposed
OSP cabling. The addition of primary protectors is not sufficient protection to connect these interfaces
metallically to OSP wiring.
Warning Statement 7012 Equipment Interfacing with AC Power Ports
This equipment shall be connected to AC mains provided with a surge protective device (SPD) at the service
equipment complying with NFPA 70, the National Electrical Code (NEC).
Cisco Firepower 4110, 4120, 4140, and 4150 Hardware Installation Guide
42
Installation Preparation