Cisco Firepower 4110 Hardware Installation Manual page 12

Front Panel
9 Pullout asset card
11 Network module 3
Note
RJ-45 Console Port
The Firepower 4100 has a standard RJ-45 console port. You can use the CLI to configure your Firepower
4100 through the RJ-45 serial console port by using a terminal server or a terminal emulation program
on a computer.
The RJ-45 (8P8C) port supports RS-232 signaling to an internal UART controller. The console port does
not have any hardware flow control, and does not support a remote dial-in modem. The baud rate is 9600.
You can use the standard cable found in your accessory kit to convert the RJ-45 to DB-9 if necessary.
Type A USB Port
You can use the external USB Type A port to attach a data storage device. The external USB drive
identifier is
• Hot swapping
• USB drive formatted with FAT32
• Boot kick-start image from the Supervisor ROMMON for discovery recovery purposes
• Copy files to and from workspace:/ and volatile:/ within local-mgmt. The most relevant files are:
• Platform bundle image upload using download image usbA:
The USB Type A port does not support Cisco Secure Package (CSP) image upload.
Network Ports
The Firepower 4100 chassis has eight fixed ports that require 1-Gb/10-Gb SFP/SFP+ transceivers (fiber
or copper). They are numbered from left to right starting with 1 and are named Ethernet 1/1 through
Ethernet 1/8. The 4100 also has two network module slots that support different numbers of ports
depending on the network module. See
See for
Each port has LEDs that represent link/activity status.
Management Port
The Firepower 4100 chassis has a management port that requires a 1-Gb fiber or copper SFP.
Cisco Firepower 4110, 4120, 4140, and 4150 Hardware Installation Guide
8
The 10-Gb network module is shown.
. The USB Type A port supports the following:
disk1:
• Core files
• Ethanalyzer packet captures
• Tech-support files
• Security module log files
Supported SFP/SFP+ and QSFP Transceivers, on page 24
10 Network module 2
The 10-Gb network module is shown.
Note
Network Modules, on page 11
the list of supported transceivers.
Overview
for the supported network modules.