Cisco Firepower 4110 Hardware Installation Manual page 77

Installation, Maintenance, and Upgrade
Figure 51: Tie Wrap Through the Box Channel of the Clamp
Tie wrap
1
Step 2
Attach the clamp to the power supply module:
a) Locate the hexagonal ventilation hole on the power supply module at the center of the plug just below the power
connector body (see the following figures).
b) Plug the snapping portion of the tie wrap into the hexagonal hole.
c) With the clamp side facing up, push the tie wrap in until it is fully engaged.
Make sure you have the correct location because you cannot remove the tie wrap from the power supply
Caution
module once you have installed it without damaging the tie wrap.
Figure 52: Flextronics Power Supply Module
1 Flextronics tie wrap
Secure the Power Cord on the AC Power Supply Module
Box channel
2
2 Hexagonal hole
Cisco Firepower 4110, 4120, 4140, and 4150 Hardware Installation Guide
73