Purpose Of This Section - GE LOGIQ E9 Service Manual

GE
D 5573152-100, R
IRECTION
Section 8-6
Replacing Top Console Parts
8-6-1

Purpose of this section

This section describes how to replace the Top Console parts.
8-6-2 Monitor assembly replacement
There are four types of LOGIQ E9 Monitors:
• Original LCD Monitor (P/N 5167953)
• LCD Monitors used in R4 original consoles, LCD Monitor V2 (5392293-21 and 5392293-22, used
in R4.x and R5 production)
• On R6 and later production, there are two Monitor versions, a 23 inch Monitor and a 22 inch OLED
Monitor. The 23 inch Monitor version may not be available in all regions.
NOTE: Before removing the Monitor, record old monitor settings or user settings if possible.
For Original LCD Monitor, see: Section
and Section
For LCD Monitor V2 (LCD and Arm Assembly used in R4.x production), see: Section
Monitor V2 removal - R4.x" on page 8-91
page 8-93.
For Monitors used in R5.x and later production), see: Section
(Ergotron Arm)" on page 8-95
page 8-100.
Manpower /
Time Total
One person /
40 minutes
NOTE: If the device is equipped with WLAN option, Velcro will be required to ensure proper installation
of the re-installed WLAN dongle.
. 2
EV
8-6-2-2 "LCD Monitor installation - R3.x and earlier" on page
and Section
Table 8-56 Manpower / Time and Tools
Refer to:
8-2-5 "Tools needed for servicing the LOGIQ E9" on page
Chapter 8 Replacement procedures
8-6-2-1 "LCD Monitor removal - R3.x and earlier" on page 8-87
and Section
8-6-2-4 "LCD Monitor V2 installation - R4.x" on
8-6-2-5 "Monitor removal - R5.x and later
8-6-2-6 "Monitor installation - R5.x and later (Ergotron)" on
Tools
LOGIQ E9 S M
ERVICE ANUAL
8-89.
8-6-2-3 "LCD
8-5.
8 - 85